Chemical Resistant Floor Coatings

Endurabond CR

High build,solventless,chemical and abrasion resistant epoxy floor coating system

Endurabond Floorshield SL

A 100% solids, high-build, self-levelling floor topping recommended for use as an aesthetic epoxy coating where a high degree of resistance to impact, abrasion, and chemical resistance are required.
Provides a seamless, decorative surface. May be applied with a non-skid aggregate finish if required.
Typical areas where this coating is used are:
Hospitals, Canteens, Factories, Laboratories, Schools, Warehouses, Stores, Showrooms, Industrial kitchens and Supermarkets.

Enduracoat EHB

GENERIC TYPE: Cross-linked polyamide epoxy.

GENERAL PROPERTIES: ENDURACOAT EHB is a self priming, high solids, mid gloss, high build epoxy mastic. It can be applied by spray, brush or roller over hand or power tool cleaned steel and is compatible with most existing coatings and tightly adhered rust. The cured film provides a tough, cleanable surface and is available in a wide variety of colours.

· Single-coat corrosion protection
· Excellent chemical resistance
· Good flexibility and lower stress upon curing than most epoxy coatings
· Excellent tolerance of damp (not wet) substrates
· Very good abrasion resistance

Enduracoat EP Sealer

Equal parts of Part A and Part B mixed prior to application.
Masonry sealer and adhesion promoter.

GENERAL PROPERTIES: Penetrating clear primer/sealer for concrete surfaces prior to application of surfacers or polyurethane membranes. Excellent fast-drying material. Priming and sealing action provides excellent adhesion for surfacers and polyurethane membranes.

Polycrete MDB

A hard wearing, self-priming, aggregate filled cementitious urethane floor topping with excellent thermal shock resistance. POLY-CRETE MDB is typically installed at a nominal ¼ inch thickness and uses a natural quartz aggregate. Recommended substrates are concrete, mild steel and polymer reinforced screeds. POLY-CRETE MDB can be installed with moisture levels up to 12 lb sf/1000 sf/24 hours and can be applied to 7-14 day old concrete. A topcoat of DUR-A-FLEX epoxy, urethane or methyl methacrylate is applied depending on performance requirements.

POLY-CRETE MDB has a wide service temperature range from -37 to 104°C. POLY-CRETE MDB is hygienic and does not harbor bacteria, possess high chemical resistance and high abrasion resistance. POLY-CRETE MDB is VOC and ADA compliant, meets USDA, FDA and CFIA Standards and gain Leed credit points.Dur-a-Flex5