Non-Slip Floor Coatings


Endurabond 450NS

Rapid cure, textured finish epoxy floor coatingwith negligible odour.

Endurabond CR

High build,solventless,chemical and abrasion resistant epoxy floor coating system

Enduracoat EHB

GENERIC TYPE: Cross-linked polyamide epoxy.

GENERAL PROPERTIES: ENDURACOAT EHB is a self priming, high solids, mid gloss, high build epoxy mastic. It can be applied by spray, brush or roller over hand or power tool cleaned steel and is compatible with most existing coatings and tightly adhered rust. The cured film provides a tough, cleanable surface and is available in a wide variety of colours.

· Single-coat corrosion protection
· Excellent chemical resistance
· Good flexibility and lower stress upon curing than most epoxy coatings
· Excellent tolerance of damp (not wet) substrates
· Very good abrasion resistance

Enduracoat EP Sealer

Equal parts of Part A and Part B mixed prior to application.
Masonry sealer and adhesion promoter.

GENERAL PROPERTIES: Penetrating clear primer/sealer for concrete surfaces prior to application of surfacers or polyurethane membranes. Excellent fast-drying material. Priming and sealing action provides excellent adhesion for surfacers and polyurethane membranes.


Enduraglaze is a one-component, non-yellowing, aliphatic, moisture-curing, polyurethane gloss coating containing UV light absorbers.
A clear topcoat for interior and exterior seamless floors. A wear layer over deck coatings and slip-resistant coatings. A concrete sealer and topcoat and an aggregate glaze. Imbedding anti-skid aggregates. Wood form coating for pre-cast concrete. Exterior and interior marine coatings. Prefinished wood products.
Outstanding colour and gloss retention. Excellent flexibility and abrasion resistance. Addition of Enduraglaze Matting Agent will reduce the gloss if necessary.

Enduragrip Epoxy Sealer

Enduragrip Epoxy Sealer is a rapid cure, high build epoxy resin designed to provide a heavy duty trafficable protective and abrasion resistant coating for concrete surfaces.
Enduragrip Epoxy Sealer is used to seal aggregate dressings to provide a durable, industrial or decorative, easy to clean, trafficable surface encompassing excellent skid resistance in both wet and dry conditions.

Enduragrip Products

A range of fast cure, 100% solids, solvent free, self-priming, high build, adhesives or bonding aggregates to asphalt and concrete.

Available as a semi-flexible polyurethane and epoxy adhesive and a rigid epoxy adhesive.

For use with high PSV aggregates to provide high friction surfaces on asphalt and concrete surfaces providing excellent vehicular skid resistance and pedestrian slip resistance.



Eurostone Flooring kit

100% solids, light weight, decorative epoxy flooring system suitable for concrete and steel substrates

Polycrete MDB

A hard wearing, self-priming, aggregate filled cementitious urethane floor topping with excellent thermal shock resistance. POLY-CRETE MDB is typically installed at a nominal ¼ inch thickness and uses a natural quartz aggregate. Recommended substrates are concrete, mild steel and polymer reinforced screeds. POLY-CRETE MDB can be installed with moisture levels up to 12 lb sf/1000 sf/24 hours and can be applied to 7-14 day old concrete. A topcoat of DUR-A-FLEX epoxy, urethane or methyl methacrylate is applied depending on performance requirements.

POLY-CRETE MDB has a wide service temperature range from -37 to 104°C. POLY-CRETE MDB is hygienic and does not harbor bacteria, possess high chemical resistance and high abrasion resistance. POLY-CRETE MDB is VOC and ADA compliant, meets USDA, FDA and CFIA Standards and gain Leed credit points.Dur-a-Flex5